Delta MS300 Series User Manual page 708

Command
SET Action continues (ON)
X0–X17
Operand
－
Sets the designated element to ON, and maintains it in an ON state, regardless of
whether the SET command is still driven. Use the RST command to set the element
as OFF.
Ladder diagram:
Command
RST Clear contact or register
X0–X17
Operand
－
Resets the designated element as described.
Element
Y, M
T, C
D
If the RST command is not executed, the status of the designated element remains
unchanged.
Ladder diagram:
Command
TMR 16-bit timer
T-K
Operand
T-D
Electrifies the designated timer coil, and the timer begins timing. The contact's action
is as follows when the timing value reaches the designated setting value (timing
value ≥ setting value):
N.O. (Normally Open) contact
N.C. (Normally Closed) contact
If the RST command is not executed, the status of the designated element remains
unchanged.
Ladder diagram:
X0
Y0–Y17 M0–M799

Y0–Y17 M0–M799

Both coil and contact are set as OFF.
Sets the current timing or count value to 0, and both the coil and
contact are set to OFF.
Sets the content value to 0.
T0–T159, K0–K32,767
T0–T159, D0–D399
TMR T5
K1000
Chapter 16 PLC Function ApplicationsMS300
Function
T0–159
－

Command code:
LD
AN
SET
Function
T0–159
 
Mode
Command code:
LD
RST
Function
Open circuit
Closed circuit
Command code:
LD
TMR
K1000
699
C0–C79 D0–D399
－
Description:
X0 Load Contact A of X0
Establish a parallel
Y0 connection to contact
B of Y0
Y1 Action continues (ON)
C0–C79 D0–D399

Description:
X0 Load Contact A of X0
Clear the contact or
Y5
register
Description:
X0 Load Contact A of X0
T5
T5 timer
Set value as K1000
－
