Delta MS300 Series User Manual page 270

Models
Frame
Power (kW)
Power (HP)
Identity Code
Rated Current for
Heavy Duty
Rated Current for
Normal Duty
00-02
Parameter Reset
Settings
 1: All parameters are read only except Pr.00-02, Pr.00-07, and Pr.00-08. Set Pr.00-02 to 0 before
changing other parameter settings.
 5: You can return the kWh displayed value to 0 even during drive operation. For example, you
can set Pr.05-26–Pr.05-30 to 0.
 6: Clear the internal PLC program (includes the related settings of PLC internal CANopen
master).
 7: Reset the related settings of CANopen slave.
 8: RUN key on the keypad is invalid; the rest of the keys work normally. Set Pr.02-00 to 0 to
unlock the setting.
 9 or 10: Reset all parameters to defaults. If you have set a password (Pr.00-08), unlock the
password (Pr.00-07) to clear the password you have set before you reset all parameters.
 For settings of 6, 7, 9, 10, 11 and 12, you must reboot the motor drive after you finish the setting.
00-03
Start-up Display

Settings
 Determines the start-up display page after power is applied to the drive. The user-defined
A B
0.75 1.5
1 2
504 505
1.7 3
2.1 3.6
0: No Function
1: Write protection for parameters
5: Return kWh displays to 0
6: Reset PLC (including CANopen Master index)
7: Reset CANopen Slave index
8: Keypad does not respond
9: Reset all parameters to defaults (base frequency is 50 Hz)
10: Reset all parameters to defaults (base frequency is 60 Hz)
11: Reset all parameters to defaults with base frequency at 50 Hz
(keep the user-defined parameter values Pr.13-01–Pr.13-50)
12: Reset all parameters to defaults with base frequency at 60 Hz
(keep the user-defined parameter values Pr.13-01–Pr.13-50)
0: F (frequency command)
1: H (output frequency)
2: U (user-defined) see Pr.00-04
3: A (output current)
Chapter 12 Descriptions of Parameter SettingsMS300
575V Models: Three-phase
C
2.2 3.7
3 5
506 507
4.2 6.6
5 8
261
D
5.5
7.5
508
9.9
11.5
Default: 0
Default: 0
7.5
10
509
12.2
15