Delta MS300 Series User Manual page 231

Chapter 11 Summary of Parameter SettingsMS300
Pr. Explanation
The Width of the Desired
02-25

Frequency Reached 2
Output Frequency Setting
02-34 for Multi-Function Output

Terminal
External Operation
02-35 Control Selection after

Reset and Reboot
02-47 Motor Zero-Speed Level

Display the Status of
02-50 Multi-Function Input
Terminal
Display the Status of
02-51 Multi-Function Output
Terminal
Display the External Multi-
02-52 Function Input Terminals
Used by PLC
Display the External Multi-
02-53 Function Output Terminals
Used by PLC
Display the Frequency
02-54 Command Executed by
External Terminal
Multi-Function Output
Terminal (Function 42):
02-58

Brake Frequency Check
Point
Internal / External Multi-
02-74 Function Input Terminal

Selection
Internal Multi-Function
02-75

Input Terminal Selection
02-78 Motor Deceleration Ratio
Automatic Positioning
02-79
Angle Setting
Automatic Positioning
02-80
Deceleration Time
0.00–599.00 Hz
0.00–599.00 Hz
0: Disable
1: Drive runs if the RUN command remains after reset or
reboot
0–65535 rpm
Monitor the status of multi-function input terminals
Monitor the status of multi-function output terminals
Monitor the status of PLC input terminals
Monitor the status of PLC output terminals
0.00–599.00 Hz (Read only)
0.00–599.00 Hz
0000–FFFFh
0000–FFFFh
4.0–1000.0
0.0–6480.0
0.00: Disable the function
0.01–100.00 sec.
222
Settings Default
2.00
0.00
0
0
Read only
Read only
Read only
Read only
Read only
0.00
0000h
0000h
200.0
180.0
0.00