Delta MS300 Series User Manual page 359

Chapter 12 Descriptions of Parameter SettingsMS300
Induction Motor (IM) or Permanent Magnet Synchronous AC Motor
05-33
Selection
Settings
05-34
Full-load Current for a Permanent Magnet Synchronous AC Motor
Settings
05-35
Rated Power for a Permanent Magnet Synchronous AC Motor
Settings
 Sets the rated power for the permanent magnet synchronous AC motor. The default is the drive's
power value.
05-36
Rated Speed for a Permanent Magnet Synchronous AC Motor
Settings
05-37
Number of Poles for a Permanent Magnet Synchronous AC Motor
Settings
05-39
Stator Resistance for a Permanent Magnet Synchronous AC Motor
Settings
05-40
Permanent Magnet Synchronous AC Motor Ld
Settings
05-41
Permanent Magnet Synchronous AC Motor Lq
Settings
05-43 Ke parameter of a Permanent Magnet Synchronous AC Motor
Settings
05-51 Motor Code
Settings
 When using Delta MSI Motor, set Pr.05-51 according to the corresponding setting value in the
table below to complete motor auto-tuning.
0: IM (Induction motor)
1: SPM (Surface permanent magnet synchronous AC motor)
2: IPM (Interior permanent magnet synchronous AC motor)
0–120% of the drive's rated current
0.00–655.35 kW
0–65535 rpm
0–65535
0.000–65.535 
0.00–655.35 mH
0.00–655.35 mH
0–65535 V/krpm
0–65535
350
Default: 0
Default: Depending on the
model power
Default: Depending on the
motor power
Default: 2000
Default: 10
Default: 0.000
Default: 0.00
Default: 0.00
Default: 0
Default: 0