Delta MS300 Series User Manual page 155

Chapter 7 Optional AccessoriesMS300
File Copy Setting Fault Description:
These faults occur when KPC-CC01 cannot perform the command after clicking the ENTER key in the
copy function.
LCD Display Fault Name
Read only Parameter and file are
(ERR1) read-only
Write in error Fail to write
(ERR2) parameter and file
Drive operating AC motor drive is in
(ERR3) operating status
Parameter locked AC motor drive
(ERR4) parameter is locked
Parameter
AC motor drive
changing
parameter is changing
(ERR5)
Fault code Fault code is not
(ERR6) cleared
Warning code Warning code is not
(ERR7) cleared
Description
The parameter/file is read-only and cannot
be written to.
1. Verify the specification in the user
manual.
If this solution does not work, contact your
local authorized dealer for assistance.
An error occurred while writing to a
parameter/file.
1. Check for any problem on Flash IC.
2. Shut down the system, wait for ten
minutes, and then restart the
system.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed while the
motor drive is in operation.
1. Verify that the drive is not in
operation.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because a
parameter is locked.
1. Check if the parameter is locked. If it
is locked, unlock it and try to set the
parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because a
parameter is being modified.
1. Check if the parameter is being
modified. If it is not being modified,
try to change that parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because an
error has occurred in the motor drive.
1. Check if an error occurred in the
motor dive. If there is no error, try to
change the setting again.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because of a
warning message given to the motor
drive.
1. Check if there is a warning message
given to the motor drive.
If this solution does not work, contact your
local authorized dealer for assistance.
146
Corrective Actions