Delta MS300 Series User Manual page 754

API
GBIN
171
D P
bit device
X Y M K
＊
S
D
Notes on operand usage:
Refer to the function specifications table for each device in series
for the scope of device usage.
 S: source device storing GRAY code. D: device storing BIN value after conversion.
Converts the GRAY code corresponding to the value of the device designated by

S that is converted into a BIN value, and stores it in the device designated by D.
 This command converts the value of the absolute position encoder connected with
the PLC's input (this encoder usually has an output value in the form of GRAY code)
into a BIN value, and stores it in the designated register.
 The valid range of S is as shown below; if you exceed this range, it is an error, and
the command does not execute.
16-bit command: 0–32,767
32-bit command: 0–2,147,483,647
 When X20 = ON, converts the GRAY code of the absolute position encoder
connected with input points X0–X17 to a BIN value and stores it in D10.
Word device
H KnX KnY KnM T
＊ ＊ ＊ ＊ ＊
＊ ＊ ＊
Chapter 16 PLC Function ApplicationsMS300
Convert GRAY code to BIN
16-bit command (5 STEP)
Continuous
C D
GBIN
execution type
＊ ＊
32-bit command (9 STEP)
＊ ＊
Continuous
DGBIN
execution type
Flag signal: none
745
Pulse
GBINP
execution type
Pulse
DGBINP
execution type