Delta MS300 Series User Manual page 175

Chapter 8 Option CardsMS300
Environment
Noise Immunity
Operation / Storage
Shock / Vibration
Resistance
8-5-4 Installation
Connecting the CMM-EIP03 to the Network
1. Switch OFF the power supply.
2. Open the front cover of the drive.
3. Connect the CAT-5e network cable to the RJ45 port on the
CMM-EIP03 (as shown in the right figure).
RJ45 PIN Definition
PIN Signal
Positive pole for data
1 Tx+
2 Tx-
Positive pole for data
3 Rx+
4 --
Table 8-30
8-5-5 Communication Parameter Settings when MS300 Connects to Ethernet
When you connect the MS300 to EtherNet, set up the communication parameters based on the table
below. The EtherNet master reads and writes the frequency command words and operation command
words for the MS300 after you set the communication parameters.
Parameter
00-20
00-21
09-30
09-75
09-76
09-77
09-78
09-79
09-80
ESD (IEC 61800-5-1, IEC 61000-4-2)
EFT (IEC 61800-5-1, IEC 61000-4-4)
Surge Test (IEC 61800-5-1, IEC 61000-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 61000-4-6)
Operation: -10–50°C (temperature), 90% (humidity)
Storage: -25–70°C (temperature), 95% (humidity)
International standards: IEC 61800-5-1, IEC 60068-2-6 / IEC 61800-5-1, IEC
60068-2-27
Definition
transmission
Negative pole for
data transmission
reception
N/C
Function
Frequency command
source
Operation command
source
Decoding method for
communication
IP setting
IP address 1
IP address 2
IP address 3
IP address 4
Netmask 1
PIN Signal Definition
5 --
Negative pole for
6 Rx-
data reception
7 --
8 --
Table 8-31
Current Set Value
The frequency command is controlled by
8
the communication card.
The operation command is controlled by
5
the communication card.
The decoding method for Delta AC motor
0
drive
0 Static IP(0) / Dynamic distribution IP(1)
192 IP address 192.168.1.5
168 IP address 192.168.1.5
1 IP address 192.168.1.5
5 IP address 192.168.1.5
255 Netmask 255.255.255.0
166
Figure 8-36
N/C
Figure 8-37
N/C
N/C
Definition of Parameter Values
Table 8-29