Setproperty Command - NXP Semiconductors freescale KV4 Series Reference Manual

Table 14-16. GetProperty Response Packet Format (Example) (continued)
GetPropertyResponse
Command packet

14.2.6.2 SetProperty command

The SetProperty command is used to change or alter the values of the properties or
options in the Kinetis Flashloader. However, the SetProperty command can only change
the value of properties that are writable—see
SetProperty Commands. If you try to set a value for a read-only property, then the Kinetis
Flashloader will return an error.
The property tag and the new value to set are the 2 parameters required for the
SetProperty command.
Table 14-17. Parameters for SetProperty Command
Byte #
0 - 3
4 - 7
Freescale Semiconductor, Inc.
Parameter Value
crc16 0x07 0x7a
responseTag 0xA7
flags 0x00
reserved 0x00
parameterCount 0x02
status 0x00000000
propertyValue 0x0000014b - CurrentVersion
Property tag
Property value
KV4x Reference Manual, Rev. 2, 02/2015
Preliminary
Table 14-31, Properties used by Get/
Command
Chapter 14 Kinetis Flashloader
231