Get/Setproperty Command Properties - NXP Semiconductors freescale KV4 Series Reference Manual

for response
Wait for 1 byte
No
from target
Reached
No
maximum
received?
retries?
Wait for 1 byte
Yes from target
Report a timeout
error (End)
No
Figure 14-26. Host reads a command response from target via FlexCAN

14.4 Get/SetProperty Command Properties

This section lists the properties of the GetProperty and SetProperty commands.
Table 14-31. Properties used by Get/SetProperty Commands, sorted by
Property
CurrentVersion
AvailablePeripherals
FlashStartAddress
FlashSizeInBytes
FlashSectorSize
FlashBlockCount
AvailableCommands
VerifyWrites
MaxPacketSize
Freescale Semiconductor, Inc.
Wait
0x5A
Yes
Wait for payload
0xA4
Yes length part from
received?
target (2 bytes)
Value
Writable Tag Value
No 01h
No 02h
No 03h
No 04h
No 05h
No 06h
No 07h
Yes 0Ah
No 0Bh
Table continues on the next page...
KV4x Reference Manual, Rev. 2, 02/2015
Preliminary
End
Wait for payload
data from target
Yes
Payload length is
less than supported
length?
Wait for CRC
checksum from
target (2 bytes)
Size
4 Current flashloader version.
4 The set of peripherals supported on this chip.
4 Start address of program flash.
4 Size in bytes of program flash.
4 The size in bytes of one sector of program flash.
This is the minimum erase size.
4 Number of blocks in the flash array.
4 The set of commands supported by the flashloader.
4 Controls whether the flashloader will verify writes to
flash. VerifyWrites feature is enabled by default.
0 - No verification is done.
1 - Enable verification.
4 Maximum supported packet size for the currently active
peripheral interface.
Chapter 14 Kinetis Flashloader
Set payload length
No to maximum
supported length
Descripion
251