Chapter 15 Reset Control Module (Rcm); Reset Memory Map And Register Descriptions - NXP Semiconductors freescale KV4 Series Reference Manual

Chapter 15
Reset Control Module (RCM)
15.1 Introduction
Information found here describes the registers of the Reset Control Module (RCM). The
RCM implements many of the reset functions for the chip. See the chip's reset chapter for
more information.
See AN4503: Power Management for Kinetis and ColdFire+ MCUs
using the RCM.

15.2 Reset memory map and register descriptions

The RCM Memory Map/Register Definition can be found here.
The Reset Control Module (RCM) registers provide reset status information and reset
filter control.
The RCM registers can be written only in supervisor mode.
Write accesses in user mode are blocked and will result in a bus
error.
Absolute
address
(hex)
4007_F000 System Reset Status Register 0 (RCM_SRS0)
4007_F001 System Reset Status Register 1 (RCM_SRS1)
4007_F004 Reset Pin Filter Control register (RCM_RPFC)
4007_F005 Reset Pin Filter Width register (RCM_RPFW)
Freescale Semiconductor, Inc.
NOTE
RCM memory map
Register name
Table continues on the next page...
KV4x Reference Manual, Rev. 2, 02/2015
Preliminary
for further details on
Width
Access Reset value
(in bits)
8 R 82h
8 R 00h
8 R/W 00h
8 R/W 00h
Section/
page
15.2.1/256
15.2.2/257
15.2.3/259
15.2.4/260
255