Agilent Technologies 8960 Series Reference Manual page 545

Changing Call Parameters
A. Set Parameters Requiring Cell Off Operating Mode
2
9
8
1. Press .
CALL SETUP
2. Press Operating Mode (
3. Press the Channel Type (
4. Press the DL Channel (
5. Press the Uplink Channel (
6. Press key to go to screen 2 of 3.
More
7. Press SRB Config (
8. Press key on the left to go to Call Control (2 of 2).
More
9. Press Generator Info (
11
13
12
10.Press the Downlink Channel Codes (
11.Press the Downlink Channel Levels (
) and select Cell Off.
F1
) key, and set the desired reference measurement channel (RMC) type.
F8
) key, and enter the downlink channel number.
F10
) key, and enter the uplink channel number.
F11
) key, and set the desired data rate for the initial signaling radio bearer.
F12
).
F3
F2
F3
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_gen_op_overview_call_parms.fm
1
3
4
5
7
6
1
3
4
5
7
6
) key, and set the channel codes.
) key, and set the power levels for the downlink channels.
Changing Call Parameters
545