Input Signal Requirements - Agilent Technologies 8960 Series Reference Manual

Hide thumbs Also See for 8960 Series:

Table of Contents

• Code Domain Power (CDP)

• Code Domain Error (CDE)

• All of the measurement results of the Waveform Quality measurement.

Measurement Description" on page 44.

Input Signal Requirements

• This measurement does not autorange, therefore the expected power level from the UE is set using the

current MS Target Power setting, or by using manual receiver power control and specifying the manual

power level. See

"Receiver Control"

The frequency of the signal being measured must be in the range of 800 MHz to 1000 MHz, or from 1700 MHz to

The level into the test set's RF IN/OUT connector must be in the range of +5 dBm to +28 dBm, in a 3.84 MHz

• Maximum measurable EVM = 35%

• Maximum measurable frequency error = ± 1 kHz

S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_meas_cod_dom_desc.fm

Code Domain Measurement Description

See "Waveform Quality