Agilent Technologies 8960 Series Reference Manual page 281

CALL:PAGing:REPeat:STATe[:SELected]
Function Sets/queries the repeat paging state. When repeat paging is off, the test set sends a single Paging
Type 1 message in response to the user's page command. When repeat paging is on, the test set
will begin sending Paging Type 1 messages in response to the user's page command and will
repeat the message every discontinuous reception (DRX) cycle until either: 1) the UE (mobile
station) responds with PRACH preambles and a valid RRC connection request or, 2) if it is
enabled, the call drop timer expires or, 3) the user issues a
Changing the repeat paging state to "Off" during a paging attempt has the same effect as
"CALL:END"
Setting Range: 0|ON|1|OFF
Query Range: 0|1
*RST Setting 0 (off)
Requirements Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:PAGING:REPEAT:STATE ON"
.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_paging.fm
"CALL:END" command to the test set.
CALL:PAGing
281