Agilent Technologies 8960 Series Reference Manual page 410

SETup:WACLeakage
SETup:WACLeakage:CONTinuous
Function Sets/queries the trigger arm state for the adjacent channel leakage measurement. The trigger
arm state determines whether the adjacent channel leakage measurement will be made once
then stop (0|OFF (single)), or automatically re-arm upon completion of one measurement and
repeat the process (1|ON (continuous)).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"SETUP:WACLEAKAGE:CONTINUOUS OFF
!Sets measurement to single trigger mode.
SETup:WACLeakage:COUNt[:SNUMber]
Function The setting form of this command performs two functions: (1) sets the number of adjacent
channel leakage measurements to be made in a multi-measurement, and (2) sets the
multi-measurement STATe command to 1 (on).
The query form returns the number of adjacent channel leakage multi-measurements to be made
when multi-measurement state is ON.
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting Off (10 when STATe = On)
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"SETUP:WACLEAKAGE:COUNT:SNUMBER 5"
!Turns on multi-measurements and sets the number of measurements to 5.
SETup:WACLeakage:COUNt:NUMBer
Function Sets/queries the number of adjacent channel leakage measurements to be made when the
multi-measurement state is ON.
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting 10
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"SETUP:WACLEAKAGE:COUNT:NUMBER 5"
!Sets the number of adjacent channel leakage multi-measurements to 5.
410
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_setup_wacleakage.fm
"