Call[:Cell]:Mncode - Agilent Technologies 8960 Series Reference Manual

CALL[:CELL]:MNCode

CALL
[:CELL]
"Diagram Conventions" on page 210
CALL[:CELL]:MNCode
Function Sets/queries the mobile network code (MNC) for the currently selected test application.
This setting cannot be changed while Operating Mode is set to "Active Cell." This setting can only
be changed when the Operating Mode is set to Cell Off (CALL:OPERating:MODE OFF).
Setting Range: 0 to 99
Query Range: 0 to 99
*RST Setting 1
Requirements Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:CELL:MNCODE 10" !Sets the current MNC setting to 10.
CALL[:CELL]:MNCode:WCDMa
Function Sets/queries the mobile network code (MNC), when using the W-CDMA test application.
This setting cannot be changed while Operating Mode is set to "Active Cell." This setting can only
be changed when the Operating Mode is set to Cell Off (CALL:OPERating:MODE OFF).
Setting Range: 0 to 99
Query Range: 0 to 99
*RST Setting 1
Requirements Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:CELL:MNCODE:WCDMA 10" !Sets the WCDMA mobile network code to 10.
:MNCode
[:SELected]
:WCDMa
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_mncode.fm
CALL[:CELL]:MNCode
<sp><num value>
? (returns num value)
271