Agilent Technologies 8960 Series Reference Manual page 595

WCDMA and FDD Manual User Messages
Table 6.
Error Message
WCDMA common measurements calibration completed
successfully.
WCDMA common measurements calibration failed due
to temperature drift. Wait for temperature to stabilize.
WCDMA common measurements calibration failed due
to oven out of range.
WCDMA common measurements calibration failed due
to loopback switch problem.
WCDMA common measurements calibration failed due
to under range condition.
WCDMA common measurements calibration failed due
to over range condition.
WCDMA common measurements calibration failed due
to correlation problem.
WCDMA common measurements calibration failed.
WCDMA common measurements calibration in
progress. Do not apply RF power during calibration
WCDMA common measurements calibration <x>%.
FDD measurement warning; Thermal Power
measurement has been closed.
FDD measurement warning; Adjacent Channel Leakage
Ratio measurement has been closed.
FDD measurement warning; Waveform Quality
measurement has been closed.
FDD measurement warning; Channel Power
measurement has been closed.
FDD measurement warning; Loopback Bit Error Ratio
measurement has been closed.
Description
The calibration procedure for WCDMA measurements
completed without problems.
The temperature in the test set was changing during
calibration, causing the calibration to fail.
Indicates an internal problem during measurement
calibration.
Indicates an internal problem during measurement
calibration.
Indicates an internal problem during measurement
calibration.
Indicates an internal problem during measurement
calibration.
Indicates an internal problem during measurement
calibration.
The measurement calibration procedure failed for an
unspecified reason.
Tells you to not apply power during measurement
calibration.
Progress indicator for the measurement calibration routine.
Indicates that a measurement has been inactivated because
of a resource conflict. This message is typically generated
when thermal power measurements are initiated.
Indicates that a measurement has been inactivated because
of a resource conflict. This message is typically generated
when adjacent channel leakage ratio measurements are
initiated.
Indicates that a measurement has been inactivated because
of a resource conflict. This message is typically generated
when waveform quality measurements are initiated.
Indicates that a measurement has been inactivated because
of a resource conflict. This message is typically generated
when channel power measurements are initiated.
Indicates that a measurement has been inactivated because
of a resource conflict. This message is typically generated
when loopback bit error ratio measurements are initiated.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_ts_err_msg_mui.fm
Manual User Error Messages
595