Agilent Technologies 8960 Series Reference Manual page 132

Step 7: End Connection
Releasing an Active Call from the Base Station
Figure 11. Process for Releasing an Active Call from the Base Station
Example 15. Programming Example
OUTPUT Test_set;"CALL:END"
OUTPUT Test_set;"CALL:CONN?"
ENTER Test_set;Call_connected
IF Call_connected THEN
! <put error handler here>
END IF
! Call is disconnected so proceed with control program
132
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_prog_generic_step7.fm
Start
Send CALL:END
command.
Send CALL:CONN?
query command.
Enter response from
CALL:CONN? query.
Call connected?
No
Proceed with control
program.
! Initiate a base station release.
! Send call connected state query.
! Program hangs here until state
! change or timer expires.
! Check if disconnection successful
Yes
Invoke error
handler.