Agilent Technologies 8960 Series Reference Manual page 326

FETCh:WACLeakage
FETCh:WACLeakage[:ALL]?
Function Queries a adjacent channel leakage ratio (ACLR) measurement result.
This query returns an integrity indicator followed by -5 MHz offset power ratio maximum, +5
MHz offset power ratio maximum, -10 MHz offset power ratio maximum, +10 MHz offset power
ratio maximum.
If the multi-measurement state is on, the result represents the average of a number of adjacent
channel leakage measurements. Multi-measurement state, by default, is off. To set up
multi-measurements, see
Query • Range: -99 to 99 dBm, 9.91 E+37
• Resolution: 0.01 dBm
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"FETCH:WACLEAKAGE:ALL?" !Returns integrity, ACLR measurements.
FETCh:WACLeakage:AVERage[:ALL]?
Function Queries the average adjacent channel leakage ratio at the following offsets: -5 MHz, +5 MHz,
-10 MHz, +10 MHz.
To set the number of measurement to average, use the command
"SETup:WACLeakage:COUNt[:SNUMber]" on page
Query • Range: -99 to 99 dBm, 9.91 E+37
• Resolution: 0.01 dB
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"FETCH:WACLEAKAGE:AVERAGE:ALL?"
!Queries the average adjacent channel leakage ratio.
FETCh:WACLeakage:ICOunt?
Function Queries the intermediate count of measurements completed in a multi-measurement.
To set up multi-measurements, see
Query Range: 0 to 999
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"FETCH:WACLEAKAGE:ICOUNT?"
!Returns the intermediate count of adjacent channel leakage ratio multi-measurements.
326
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_fetch_wacleakage.fm
"SETup:WACLeakage:COUNt[:SNUMber]"
"SETup:WACLeakage:COUNt[:SNUMber]"
.
410.
.