Call:cpichannel - Agilent Technologies 8960 Series Reference Manual

CALL:CPIChannel

CALL :CPIChannel
"Diagram Conventions" on page 210
CALL:CPIChannel[:SLEVel]
Function Sets/queries the common pilot channel's initial power offset. This command sets the power offset
level and turns on the power offset.
This setting cannot be changed while in active cell operating mode. Attempting to change this
setting while in this mode results in the following error message: "Command Rejected. Change
Not Allowed in Active Cell Mode." Use the cell off operating mode when changing this value.
Setting Range: -20.00 dB to 0 dB
Resolution: 0.01
Query Range: -20.00 dB to 0 dB
Resolution: 0.01
*RST Setting -4.8 dB
Requirements Test Application Revision: A.02 and above.
Programming Example
OUTPUT 714;"CALL:CPICHANNEL:SLEVEL -10"
<sp><num value>[DB]
[:SLEVel]
? (returns num value)
:LEVel <sp><num value>[DB]
? (returns num value)
:STATe <sp>1|0N|0|0FF
? (returns 1|0)
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_cpichannel.fm
CALL:CPIChannel
253