Agilent Technologies 8960 Series Reference Manual page 583

Hide thumbs Also See for 8960 Series:
Table of Contents

Advertisement

AFANalyzer Troubleshooting
AFANalyzer Troubleshooting
Possible Setup Issues
During remote operation of the Audio Analyzer, you should always set the Trigger Arm to Single. The length of
time required to return a measurement over GPIB using continuous triggering varies, but is always longer
than when using single triggering. Continuous triggering can also cause problems when the INITiate:DONE?
query is used.
The Detector Type selected (peak or rms) also sets how Audio Level measurements are displayed; as a peak
value or an rms value. When comparing returned values over GPIB to your specifications, be sure to take into
account the type of detector being used.
, regardless of the Detector Type selected, and cannot exceed
The Expected Peak Voltage is always set in V
peak
20 V
(14.1 V
).
peak
rms
For accurate measurements, always set all Audio Analyzer setup parameters to their proper settings for the
measurement being made. The SINAD and Distortion measurements typically use different settings than the
Audio Level measurement. See
"Audio Analyzer Measurement Description" on page 33
and
"Audio Analyzer
Block Diagram" on page
35.
For very low level audio signals, use the 100 Hz BW BPF filter to reduce the affects of noise (see
"Audio Level
Measurement Description" on page
32).
For accurate Audio Frequency measurements where more than one signal may be present, use the 100 Hz BW
BPF filter to isolate the desired signal (see
"Audio Level Measurement Description" on page
32).
Interpreting Integrity Indicator Values
See
"Integrity Indicator" on page
190.
If over range (5) is returned, the input level is greater than 4.9 dB above the Expected Peak Amplitude value
or the maximum input level of 20 volts peak.
If under range (6) is returned, the input level is lower than 8 dB below the Expected Peak Amplitude value.
If the signal has both over range and under range conditions, only the over range condition (5) is indicated.
583
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_ts_afan.fm

Advertisement

Table of Contents
loading

Table of Contents