Agilent Technologies 8960 Series Reference Manual page 548

Changing UE TX Power Levels
A. Using Closed Loop Power Control
1. Press the
CALL SETUP
2. Press the key on the right side two times to go to screen 3 of 3.
More
3. Press the MS Target Power (
4. Press the UL CL Power Ctrl (
control to active.
Closed loop power control uses the power control algorithm set with the Pwr Ctl Algorithm (
NOTE
key. However, the operating mode must be Cell Off to set this parameter. See
Parameters Requiring Cell Off Operating Mode" on page 545
B. Controlling the UE's TX Power Manually
1. Press the
CALL SETUP
key.
) key, and set the desired average transmit power of the UE.
F7
) key, and select Active bits. This sets the uplink closed loop power
F8
key.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_gen_op_overview_tx_level.fm
1
3
4
2
1
3
4
2
Changing UE TX Power Levels
"A. Set
for instructions.
)
F9
548