Agilent Technologies 8960 Series Reference Manual page 308

CALL:UPLink
CALL:UPLink:PRAChannel:SCODe
Function Sets/queries the uplink physical random access channel's scrambling code.
This setting cannot be changed while the active cell operating mode. Attempting to change this
setting while in this mode will result in the following error message: "Command Rejected.
Change Not Allowed in Active Cell Mode." Use the cell off operating mode to change this setting.
Setting Range: 0 to 8191
Resolution: 1
Query Range: 0 to 8191
*RST Setting 0
Requirements Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:UPLink:PRAChannel:SCODe 5"
CALL:UPLink:PRAChannel:SIGNature
Function Sets/queries the uplink physical random access channel's signature value.
This setting cannot be changed while the active cell operating mode. Attempting to change this
setting while in this mode will result in the following error message: "Command Rejected.
Change Not Allowed in Active Cell Mode." Use the cell off operating mode to change this setting.
Setting Range: 0 to15
Resolution: 1
Query Range: 0 to 15
*RST Setting 0
Requirements Test Application Revision:A.02 and above
Programming Example
OUTPUT 714;"CALL:UPLink:PRAChannel:SIGNature 11" !Set the PRACH signature to 11.
308
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_uplink.fm