Agilent Technologies 8960 Series Reference Manual page 377

INITiate:<measurement mnemonic>[:ON]
Function These commands initiate (start) the following measurements:
• AFANalyzer - Audio Frequency Analyzer measurements
• WACLeakage - Adjacent Channel Leakage
• WBERror - Loopback Bit Error Ratio measurement
• WCDomain - Code Domain measurements
• WCPower - Channel Power measurement
• WOBWidth - Occupied Bandwidth measurement
• WSEMask - Spectrum Emission Mask measurement
• WTPower - Thermal Power measurement
• WWQuality - Waveform Quality measurement
This command also queries the active state using the ON? keyword in place of a measurement
mnemonic.
The INITiate command is associated with the SETup
"FETCh? Subsystem" on page
One or more measurements can be initiated with the same program line (see
Measurements" on page 180
This command is also used to activate a measurement. See
(how INIT commands are used)" on page
Range AFAN|WACL|WBER|WCD|WCP|WOBW|WSEM|WTP|WWQ
Requirements Test Application Revision: A.01 and above
Test Application Revision: A.02 added WCDomain, WSEMask, and WOBWidth.
Programming Example
OUTPUT 714;"INITIATE:WCPOWER;WQUALITY:ON"
!Initiates a channel power and a waveform quality measurement.
INITiate:ON?
Function Queries the measurements that are on. Returns a comma separated list of measurement
mnemonics.
Query Range: AFAN|WACL|WBER|WCD|WCP|WOBW|WSEM|WTP|WWQ|NONE
Requirements Test Application Revision: A.01 and above
Test Application Revision: A.02 added WCDomain, WSEMask, and WOBWidth.
Programming Example
OUTPUT 714;"INITIATE:ON?"
314.
and the Programming Example below).
374.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_initiate.fm
"SETup Subsystem" on page 399
"Concurrent
"INITiate Programming Examples
INITiate
and the
377