Agilent Technologies 8960 Series Reference Manual page 225

CALL:AICHannel[:SLEVel]
Function Sets/queries the acquisition indicator channel's initial power offset. This command sets the power
offset level and turns on the power offset.
This setting cannot be changed while in active cell operating mode. Attempting to change this
setting while in this mode results in the following error message: "Command Rejected . Change
Not Allowed in Active Cell Mode." Use the cell off operating mode when changing this value.
Setting Range: -20.00 dB to 0 dB
Resolution: 0.01
Query Range: -20.00 dB to 0 dB
Resolution: 0.01
*RST Setting -9.9 dB
Requirements Test Application Revision: A.02 and above.
Programming Example
OUTPUT 714;"CALL:AICHANNEL:SLEVEL -13DB" !Sets the
CALL:AICHannel:CCODe
Function Sets/queries the acquisition indicator channel's channelization code.
This setting cannot be changed while in active cell operating mode. Attempting to change this
setting while in this mode results in the following error message: "Command Rejected While in
Active Cell Mode." Use the cell off operating mode when changing this value.
Setting Range: CODE6|CODE7|CODE10|CODE11
Query Range: CODE6|CODE7|CODE10|CODE11
*RST Setting CODE10
Requirements Test Application Revision: A.02 and above.
Programming Example
OUTPUT 714;"CALL:AICHANNEL:CCODE CODE6"
CALL:AICHannel:LEVel
Function Sets/queries the acquisition indicator channel's initial power offset.
This setting cannot be changed while in active cell operating mode. Attempting to change this
setting while in this mode results in the following error message: "Command Rejected . Change
Not Allowed in Active Cell Mode." Use the cell off operating mode when changing this value.
Setting Range: -20.00 dB to 0 dB
Resolution: 0.01
Query Range: -20.00 dB to 0 dB
Resolution: 0.01
acquisition indicator channel's power offset to -13 dB.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_aichannel.fm
CALL:AICHannel
225