Agilent Technologies 8960 Series Reference Manual page 306

CALL:UPLink
CALL:UPLink:CHANnel
Function Sets/queries the uplink channel number (FDD UL UARFCN).
This setting cannot be changed while the active cell operating mode. Attempting to change this
setting while in this mode will result in the following error message: "Command Rejected.
Change Not Allowed in Active Cell Mode." Use the cell off operating mode to change this setting.
Setting Range:
• 12-287
• 4095 - 4270
• 4375 - 4600
• 8525 - 8950
• 9225 - 9925
Query Range:
• 12-287
• 4095 - 4270
• 4375 - 4600
• 8525 - 8950
• 9225 - 9925
*RST Setting 9300
Requirements Test Application Revision: A.01 and above
Programming Example
OUTPUT 714;"CALL:UPLINK:CHANNEL?" !Queries the FDD UL UARFCN.
CALL:UPLink:DPCChannel:POWer:INITial?
Function Queries the expected initial power level for the uplink dedicated physical control channel.
Query Range: -50 to 24 dBm and 9.91E+37 (NAN)
Requirements Test Application Revision: A.02.25 and above
Programming Example
OUTPUT 714;"CALL:UPLINK:DPCC:POWER:INITIAL?"
306
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_uplink.fm