CALL:PICHannel
CALL:PICHannel:LEVel
Function
Sets/queries the page indicator channel's initial power offset.
This setting cannot be changed while in active cell operating mode (when available). Attempting
to change this setting while in this mode results in the following error message: "Command
Rejected. Change Not Allowed in Active Cell Mode." Use the cell off operating mode when
changing this value.
Setting
Range: - 20 to 0 dB
Resolution: 0.01
Query
Range: -20 to 0 dB
Resolution: 0.01
*RST Setting
-9.9 dB
Requirements
Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:PICHANNEL:LEVEL -10DB"
CALL:PICHannel:STATe
Function
Sets/queries the state of the page indicator channel's initial power offset.
Setting
Range: 1|ON | 0|OFF
Query
Range: 1|0
*RST Setting
1 (on)
Requirements
Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:DPCHANNEL:STAT OFF"
CALL:PICHannel:DATA
Function
Sets/queries the page indicator channel's data pattern. The pattern can be set to either all ones or
all zeros.
Setting
Range: ZERos|ONEs
Query
Range: ZER|ONES
*RST Setting
All Zeros
Requirements
Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:PICHANNEL:DATA ZEROS" !Sets the paging indicator channel data to all zeroes.
284
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_pichannel.fm