Agilent Technologies 8960 Series Reference Manual page 568

Hide thumbs Also See for 8960 Series:

Table of Contents

Rear Panel Connectors

This BNC connector provides the capability for you to trigger measurements or instruments from an external

source. Setting the Trigger Source setting to External for measurements or instruments which support this

feature causes the measurement or instrument to trigger when a positive-going TTL compatible pulse is

applied to this connector. Currently, the only measurement or instrument which supports this feature is the

Spectrum Monitor.

This BNC connector allows you to synchronize the test set to other equipment and is configured by setting

Frame Trigger Parameters.

This DB-15 connector allows you to simultaneously route the test set's display to another monitor.

10 MHZ REF IN

This BNC connector accepts an external 10 MHz timebase signal. The nominal input impedance is 50 ohm.

This version of test set can only accept a 10 MHz timebase signal.

10 MHZ REF OUT

This BNC connector provides a 10 MHz timebase signal to external test equipment. The accuracy of this signal

is determined by the timebase used. The nominal output impedance is 50 ohm with a typical level of 0.5 V rms.

S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_gen_rearpanel_con.fm