Agilent Technologies 8960 Series Reference Manual page 309

Hide thumbs Also See for 8960 Series:

Table of Contents

CALL:UPLink:TIMing[:OFFSet]

Sets/queries the uplink physical random access channel's timing offset.

This setting cannot be changed while the active cell operating mode. Attempting to change this

setting while in this mode will result in the following error message: "Command Rejected.

Change Not Allowed in Active Cell Mode." Use the cell off operating mode to change this setting.

Range: EARLy|NORMal|LATe

Range: EARL|NORM|LAT

*RST Setting

Requirements

Test Application Revision:A.02.25 and above

Programming Example

OUTPUT 714;"CALL:UPLink:TIMing EARLy" !Set the PRACH timing offset to early.

S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_uplink.fm