Agilent Technologies 8960 Series Reference Manual page 133

Releasing an Active Call from the Mobile Station Figure 12. Process for Terminating an Active
Call from the Mobile Station
The test set cannot initiate a call disconnection from the mobile station. You must manually push
NOTE
the end button on the mobile station or send commands to a test bus built into the mobile station.
For a mobile station release where the call is terminated by physically pushing a button on the
phone (as opposed to using a test bus) ensure that the call-state-change-detector timeout time is
long enough to allow the end button to be pushed.
Example 16. Programming Example
OUTPUT Test_set;"CALL:CONN:TIM 5" !Set timeout time to 5 seconds.
OUTPUT Test_set;"CALL:CONN:ARM"
Start
Send
CALL:CONN:TIM
command.
Send
CALL:CONN:ARM
command.
Send CALL:CONN?
query command.
Terminate the call
from mobile station.
Enter response from
CALL:CONN? query.
Call connected?
No
Proceed with control
program.
!Arm the change detector.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_prog_generic_step7.fm
Yes
Invoke error
handler.
Step 7: End Connection
133