Set Uplink Channel Levels - Agilent Technologies 8960 Series Reference Manual

Hide thumbs Also See for 8960 Series:

Table of Contents

Step 2: Configure Test Set and UE Parameters

Set Uplink Channel Levels

As the example below illustrates, you can specify which closed loop power control bit sequence is sent on the

downlink DPCCH.

It is important for you to specify what uplink power level the test set should expect by setting the MS Target

Power. (In Active Cell mode, this command forces the UE to the specified output power. In FDD Test Mode,

since the 8960 is not performing active closed loop power control of the uplink, this command does not change

the UE's output power.) Setting the MS Target Power automatically sets the receiver's expected power

accordingly.

! Uplink Channel Levels

OUTPUT Testset;"CALL:CLPC:UPL:MODE ACT"

OUTPUT Testset;"CALL:MS:POW:TARG 0 DBM"

! Call Control

OUTPUT Testset;"CALL:PAG:IMSI '1234567890'"

OUTPUT Testset;"CALL:OPER:MODE CALL"

S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_prog_getting_started_step2.fm