Call[:Cell]:Srbearer:cchannel:dedicated - Agilent Technologies 8960 Series Reference Manual

CALL[:CELL]:SRBearer:CCHannel:DEDicated

CALL :
SRBearer:CCHannel:DEDicated
[:CELL]
"Diagram Conventions" on page 210
CALL[:CELL]:SRBearer:CCHannel:DEDicated:BPS3400[:CCODe]
Function Sets/queries the downlink dedicated physical channel's (DPCH) channelization code during the
"setup" phase of connection setup when
is set to BPS3400.
When
channelization code will be determined by the UTRA FDD DL DPCH 12.2 RMC channelization
code ("CALL:DPCHannel:RMC12:CCODe"
This setting cannot be changed while the active cell operating mode. Attempting to change this
setting while in this mode will result in the following error message: "Command Rejected.
Change Not Allowed in Active Cell Mode." Use the cell off operating mode to change this setting.
Setting Range:
CODE12|CODE13CODE20|CODE21|CODE40|CODE43|CODE58|CODE126|CODE127|
CODE142|CODE153|CODE174|CODE235|CODE255
Query Range:
CODE12|CODE13CODE20|CODE21|CODE40|CODE43|CODE58|CODE126|CODE127|
CODE142|CODE153|CODE174|CODE235|CODE255
*RST Setting CODE12
Requirements Test Application Revision: A.02 and above
Programming Example
OUTPUT 714;"CALL:CELL:SRBearer:CCHannel:DEDicated:BPS3400:CCODE CODE58"
"CALL[:CELL]:SRBearer:CCHannel:DEDicated:DRATe"
CALL[:CELL]:SRBearer:CCHannel:DEDicated
:BPS3400
[:CCODe]
<sp>BPS3400|BPS13600
:DRATe
? (returns BPS3400|BPS13600
"CALL[:CELL]:SRBearer:CCHannel:DEDicated:DRATe"
).
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_call_srbearer.fm
<sp>CODE12|CODE13|
CODE20|CODE21|
CODE40|CODE43|
CODE58|CODE126|
CODE127|CODE142|
CODE153|CODE174|
CODE235|CODE255
is set to BPS13600, the DPCH
291