Agilent Technologies 8960 Series Reference Manual page 610

+200 through +299 Error Message Descriptions
Description
A device-specific error indicates that the instrument has detected an error that occurred because some
operations did not properly complete, possibly due to an abnormal hardware or firmware condition. For
example, an attempt by the user to set an out of range value will generate a device specific error.
When one of these errors is generated, the +200 errors bit in the questionable error status register is set.
Table 7.
Error Message
+201 No Response to RRC Connection Setup
+202 No Response to RRC Connection Release
+203 No Response to Activate RB Test Mode
+204 No Response to De-Activate RB Test Mode
+205 No Response to Close UE Test Loop
+206 No Response to Radio Bearer Setup
+208 No response to Identity Request
+209 Call Disconnected. No Signal Found on Uplink
DPCH
+210 Call Disconnected. Signal Lost on Uplink DPCH
+200 through +299 Error Message Descriptions
No "RRC Connection Complete" message was received
from the UE. However, the BS Origination process is
allowed to proceed.
No "RRC Connection Release Complete" message was
received from the UE. However, the BS Release process is
allowed to proceed.
No "Activate Radio Bearer Test Mode Complete" message
was received from the UE. However, the BS Origination
process is allowed to proceed.
No "De-Activate Radio Bearer Test Mode Complete"
message was received from the UE. However, the BS
Release process is allowed to proceed.
No "Close UE Test Loop Complete" message was received
from the UE. However, the BS Origination process is
allowed to proceed.
No "Radio Bearer Setup Complete" message was received
from the UE. However, the BS Origination process is
allowed to proceed.
The test set did not receive an identity response message
from the UE. However, the Location Update process is
allowed to proceed.
The test set could not find a valid DPCH signal within 2
seconds of sending the "RRC Connection Setup" layer 3
message during a BS Origination procedure or sending
either the "Transport Channel Reconfiguration" or
"Physical Channel Reconfiguration" layer 3 messages
during a Handoff procedure.
The test set determined that a link failure occurred due to
loss of synchronization with the embedded pilot in the
uplink DPCH.
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_ts_err_msg_pos200.fm
Description
610