Agilent Technologies 8960 Series Reference Manual page 634

Hide thumbs Also See for 8960 Series:

Table of Contents

Test Set Beeper

This parameter allows you to change the beeper state to on or off. A beep will indicate error conditions caused

during manual or remote operation of the test set.

A 100 ms, 1.24 kHz audible tone (beep) is generated when an error message is logged and the beeper state is

set to on. If two errors are generated in quick succession, two beeps are generated to indicate that more than

one error has been logged.

The beeper state can be manually set in the Instrument Setup window found in the SYSTEM CONFIG screen.

OUTPUT 714;"SYSTEM:BEEPER:STATE OFF"