Signaling Radio Bearer Configuration; Gpib Commands For Setting Dtch Parameters; Related Topics - Agilent Technologies 8960 Series Reference Manual

Setting Downlink Parameters
Channel Power measurement. (See "How to make power measurements on PRACH preambles." on page 23.)
Once the random access procedure has been initiated with Call Limit set to "ON", the Test Set will appear to
be "hung" indefinitely. You must end the call to terminate the procedure and return the Call Status to "IDLE".
(See "End a Connection" on page 553 or "CALL:END" on page 261.)
Call Limit must be OFF for any random access procedure, such as Location Update or BS Origination to be
successful.

Signaling Radio Bearer Configuration

The signaling radio bearer (SRB) configuration can be set to either a 3.4k DCCH or a 13.6 DCCH. When the
3.4k DCCH configuration is used, the downlink DPCH channelization code to be used during the "Setup"
phase of establishing a connection can be specified. See
"CALL[:CELL]:SRBearer:CCHannel:DEDicated:BPS3400[:CCODe]" on page 291. When the 13.6 DCCH
configuration is used, the channelization code is the same as that for the 12.2k RMC. See
"CALL:DPCHannel:RMC12:CCODe" on page 257.

GPIB Commands for Setting DTCH Parameters

• Channel Type - "CALL:DPCHannel:TYPe" on page 259
• Downlink DTCH Data - "CALL:DTCHannel:DATA" on page 260
• Downlink Channel number - "CALL:CHANnel" on page 235
• Downlink Paging Indicator Channel Data - "CALL:PICHannel" on page 282
• Call Drop Timer State - "CALL:CONNected:DROP:TIMer[:STATe][:SELected]" on page 242
• Call Limit State - "CALL:CONNected:LIMit[:STATe][:SELected]" on page 249
• Signaling Radio Bearer Configuration - "CALL[:CELL]:SRBearer:CCHannel:DEDicated:DRATe" on page
292

Related Topics

"Active Cell Operating Mode" on page 64
83
S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_gen_bse_dl_dtch_parms.fm