Transient Settings Screen; Table 6-26: Available Transient Settings Screen Soft Keys - Pacific Power Source AFX Series Operation Manual

6.7.6

TRANSIENT SETTINGS Screen

The TRANSIENT SETTINGS screen defines operation of transient execution.
Available settings are:
Continuous Self Calibration
Auto RMS
Cycle Reset
The soft keys on the TRANSIENT SETTINGS screen are listed in the table below
SOFT KEY
-
-
-
-
Back (SK5)

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
This CSC mode is similar to the CSC mode for steady state
operation but applies to transient mode.
This field allows enabling or disabling of the Auto RMS
mode for transient mode operation. Refer to section 6.6.13,
"AUTO RMS Function – Transients" for further details.
When enabled, the CYCLE RESET mode will cause repeated
executions of the transient as determined by the repeat
count or the continuous execution setting to re-sync to the
start phase angle set for the start of each transient. When
disabled, repeats of the transients start immediately after
the previous execution completes with no resync. With
Cycle Reset on, there may be up to one period of the AC
frequency of delay added between successive runs.
Note: In UPC Compatibility mode, Cycle Reset is default on.
Description
Return to previous screen

Table 6-26: Available TRANSIENT SETTINGS screen soft keys

AFX SERIES® OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 160 of 485