Pacific Power Source AFX Series Operation Manual page 293

Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]MODE#?
Returns protection mode for the selected phase # (# = 1, 2, or 3). If #
is omitted, returns protection mode for all phases in comma
separated format.
Note: When the phase suffix is 1, 2 or 3 the possible return
categories are from 0 to 4. With suffix is omitted, this command will
return MIXED(5) if modes for each phase are not the same.
For example, if in split phase mode phase A (suffix 1) is in VOLTAGE
mode but phase B (suffix 2) is in CURRENT mode, the query
SOUR:MODE? you will return MIXED:
SOUR:MODE1? = VOLTAGE and SOUR:MODE2? = CURRENT ->
SOUR:MODE? = MIXED
If both or phases are set to the same mode, the actual mode will be
returned:
SOUR:MODE1? = VOLTAGE and SOUR:MODE2? = VOLTAGE ->
SOUR:MODE? = VOLTAGE
<cr>
Available protection modes:
0 = NONE
1 = VOLTAGE
2 = CURRENT
3 = POWER
4 = KVA
5 = MIXED
SOUR:MODE?
VOLTAGE, VOLTAGE, VOLTAGE
[SOURce:]PROTect[:RMS]:POWer[:STATe] <ON|OFF>
This command turns the true power protection on or off.
< 0 | OFF | 1 | ON >
<b> | <cr>
PROT:POW ON
[SOURce:]PROTect[:RMS]:POWer[:STATe]?
<b>
PROT:POW?
1
[SOURce:]PROTect[:RMS]:POWer:LEVel <LEVEL>
This command sets the true power protection trip level. Setting is in
KW.
< LEVEL >
<nr2>
PROT:POW:LEV 5
[SOURce:]PROTect[:RMS]:POWer:LEVel?
<b>
PROT:POW:LEV?
5.000
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 293 of 485