Scope Measurements - Pacific Power Source AFX Series Operation Manual

6.5.2

Scope Measurements

Scope measurements allow all voltage and current phases to be captured and displayed in
the time domain. From one to four cycles of the fundamental frequency can be displayed.
Display modes include all voltages, all currents, both voltage and current or individual phase
selected voltage and current. Use the "Scope" soft key from the Measurement screen to
select Scope measurements.
Note that voltage scope captures can be set for Line to Neutral voltage or Line to Line
Voltage when in three phase mode. To select the desired mode, use the Select Channel soft
key.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
AFX SERIES® OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 128 of 485