Pacific Power Source AFX Series Operation Manual page 462

Error Source Code
Front panel 107
Error
Front panel 108
Error
Front panel 109
Error
Front panel 110
Error
Front panel 111
Error
Front panel 115
Error
Front panel 116
Error
Front panel 117
Error
Front panel 118
Error
Front panel 119
Error
Front panel 120
Error
Front panel 121
Error
Front panel 122
Error
Front panel 124
Error
Front panel 125
Error

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Category Error Message
Error Redundant segments
were combined.
Error Redundant steps were
combined.
Error Transient step mode not
available on UPC
compatible mode.
Error System is about to
reboot.
Error Cannot reboot system.
Error Unable to renew the
DHCP lease. Changing to
Auto-IP mode.
Error Failed starting firmware
update.
Error Unable to execute this
action with output
enable.
Error Frequency set point
cannot change due to
waveform saturation.
Error Frequency set point
cannot change due to
user limit.
Error Frequency not allowed in
"DC mode".
Error Waveform set point
cannot change due to
waveform saturation.
Error Cannot load program.
Run PROG:CHECK? for
more information.
Error LAN interface not
available.
Error Remote inhibit cannot be
disabled in this model.
AFX SERIES® OPERATION MANUAL
Service and Maintenance
SECTION 13:
Possible Cause
Optimization. Segment
data received contained
redundant segments
which were removed
Optimization. List Step
data received contained
redundant steps which
were removed
Setting conflict. Step
mode only supported in
AFX mode.
Warning, Reboot
imminent
Soft reboot failed. Front
panel could not reboot
itself.
LAN Error. IP address
lease from DHCP expired
Firmware Update Error.
Unable to start firmware
update
Setting conflict.
Requested action not
possible with output ON
Setting conflict. In
extended voltage range,
frequency range is
restricted. Max peak
voltage is reduced
outside this range and if
there is a DC offset
programmed, the peak of
the voltage exceeds the
max. limit.
Setting conflict.
Frequency set point
outside User Limits
Setting conflict. No
frequency setting applies
in DC mode
Setting conflict. The crest
factor of the waveform
selected would result in a
peak voltage that exceeds
the max peak voltage
supported. Or combined
AC peak + DC
programmed exceeds
max peak voltage
Setting conflict
LAN Error. No LAN
connection
Remote Inhibit always
enabled. Unit was bought
Resolution
Not needed
Not needed
Switch to AFX mode or
use Segments
Wait
Try recycling power. If
error persists, contact
customer service
Renew IP lease of use
Auto IP mode
Check for correct
firmware image file and
version.
Turn output OFF
Reduce programmed
RMS and/or DC value.
Change User Limits or
frequency setting
Change to AC or AC+DC
mode
Reduce waveform crest
factor ratio or reduce
programmed RMS and/or
DC value.
Use PROG:CHECK?
Command to query
conflict details
Check connection to LAN
Connect Remote Inhibit
input as needed.
Page 462 of 485