Pacific Power Source AFX Series Operation Manual page 466

Error Source Code
Front panel 188
Error
Front panel 189
Error
Front panel 190
Error
Front panel 191
Error
Front panel 192
Error
Front panel 193
Error
Primary Fault 200
Primary Fault 201
Primary Fault 202
Primary Fault 203
Primary Fault 204
Primary Fault 205
Primary Fault 206
Primary Fault 207
Primary Fault 208
Primary Fault 209
Primary Fault 210
Primary Fault 211

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Category Error Message
detected. Going to
inactive state.
Error One or more units are not
energized or have a
failure.
Error Incompatible node
detected.
Error Master unit nodes not
found.
Error Fast scan failed.
Error Undetectable node exists.
Error An invalid firmware type
exists.
Error LLC primary/auxiliary
current peak limit
exceeded.
Error LLC/PFC gate driver fault
or hardware OVP.
Error Controller missed
heartbeats from master
front panel.
Error LLC primary current
average limit exceeded.
Error LLC auxiliary current
average limit exceeded.
Error PFC current peak limit
exceeded.
Error PFC DC bus voltage limit
exceeded.
Error Gate driver fault
Error Input buck switching
time.
Error AC input current
exceeded RMS limit for
too long.
Error Unbalanced current in
PFC boost converters.
Error PFC efficiency protection.
AFX SERIES® OPERATION MANUAL
Service and Maintenance
SECTION 13:
Possible Cause
Error during discovery.
Error with one or more
Auxiliary units found
during discovery
Error during discovery.
Error with one or more
Auxiliary units found
during discovery
Error during discovery.
One or more nodes in
Master unit not found
Error during discovery.
Fast scan discovery failed
An inconsistency was
detected in the power
source's internal
communication network.
Firmware Error. One or
more nodes report invalid
firmware type
Gate driver fault occurred
in Input Buck Converter.
Resolution
from System menu to
recover
Check all parallel cables
between units. Make sure
all units are powered on.
Run parallel unit
discovery from System
menu to recover
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Check for correct
firmware image file and
version.
Check for correct AC
input voltage connection.
Page 466 of 485