Pacific Power Source AFX Series Operation Manual page 261

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]CONFIG:DC <b>
Selects alternative DC loop compensation mode for improved DC
transient response.
The effect of this command depends on the selected output mode as
follows:
AC Mode: No effect
DC Mode: Changes the DC loop compensation
AC+DC Mode: No effect
Note: Available in units with Firmware revision 1.6.0 or higher.
< 0 | 1 > ( 0 = Normal loop, 1 = Faster Loop )
<b>
SOUR:CONFIG:DC 1
[SOURce:]CONFIG:DC?
<b>
CONFIG:DC?
0
[SOURce:]CONFIG:HFreq <b>
This command enables high-frequency output current protection
extension mode. In this mode, the protection for high frequency
content at the output of the power source is held off for up to 2
seconds to allow short time events to ride through without tripping
the normal protection mode.
Note: Available in units with Firmware revision 1.6.6 or higher.
< 0 | OFF | 1 | ON >
<b>
SOUR:CONFIG:HF 1
[SOURce:]CONFIG:HFreq?
<b>
CONFIG:HF?
1
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
( 0 = Off, 1 = On)
Page 261 of 485