Communication Gpib Commands - Pacific Power Source AFX Series Operation Manual

Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

8.9.10 Communication GPIB Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
SYSTem:COMMunicate:USB:LAN:APPly
Applies IP settings for Virtual USB Lan interface.
None
N/A
SYST:COMM:USB:LAN:APP
SYSTem:COMMunicate:USB:LAN:MASK
Sets the embedded webserver virtual IP Mask Address for USB
interface.
IP Mask
<cr>
SYST:COMM:USB:LAN ON
SYSTem:COMMunicate:USB:LAN:MASK?
<cr>
SYST:COMM:USB:LAN:MASK?
255.255.255.0
SYSTem:COMMunicate:GPIB:ADDress <nr1>
This command sets the GPIB address.
< 1..30 >
<nr1>
SYST:COMM:GPIB:ADD 5
SYSTem:COMMunicate:GPIB:ADDress?
<nr1>
SYST:COMM:GPIB:ADD?
5
SYSTem:COMMunicate:GPIB:ENABle
Enables access to embedded webserver using virtual IP Address
through USB interface.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:GPIB:EANB 1
SYSTem:COMMunicate:GPIB:ENABle?
<b>
SYST:COMM:GPIB:ENAB?
1
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 357 of 485