Pacific Power Source AFX Series Operation Manual page 387

Command Syntax
Description
Parameters
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
RESET STATE

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
*OPC
The Operation Complete (OPC) command sets bit 0 in the Standard
Event Status Register when all pending operations have finished.
Optional: < BLOCK | 0 | NOBLOCK | 1>
*OPC
*OPC? < BLOCK | 0 | NOBLOCK | 1>
IEEE488.2 standard command. The parameter is optional.
The argument is optional, if it is not sent:
• In UPC compatible mode default argument will be NONBLOCK or
1.
• In normal mode default argument will be BLOCK or 0.
*OPC? BLOCK | 0
Returns 1 when all pending overlapped operations have been
completed. It can be used to cause the controller to wait for
commands to complete.
*OPC? NOBLOCK | 1
Returns 1 if all pending overlapped operations have been completed
or 0 if there are pending overlapped operations. It will not cause the
controller to wait for commands to complete. Pending overlapped
operations can be a transient or a soft start using ramp time/slew
rates.
<b>
*OPC?
1
*RST
RESET. The *RST command (reset) has the same effect as an IEEE-488
Device Clear bus command but can be used over the RS232C, USB or
LAN interface as well. This command resets the unit to its power on
default state.
None
n/a
FORM 3
VOLT:AC 0.0000
VOLT:DC 0.0000
CURR:AC 41.6667
CURR:DC 20.8333
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
VOLT:MODE
COUPLING
RANGE
AC
DC
AC
Page 387 of 485