Pacific Power Source AFX Series Operation Manual page 280

Commands
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]WAVEFORM:AUTORMS <BOOLEAN>
If enabled, the value of the waveform is normalized in order to match
the RMS set point.
If disabled, the waveform is reproduced without any normalization.
This function is useful for waveform substitution at the steady state
level.
Note: This function is related to the AUTORMS function in the
transient segment but it is not the same.
Note: UPC has AUTORMS always enabled for steady state. It is not an
option in UPC Mode.
0 | 1 | ON | OFF
<b>
WAVEFORM:AUTORMS OFF
[SOURce:]WAVEFORM:AUTORMS?
<b>
SOURce:WAVEFORM:AUTORMS?
0
[SOURce:]WAVEFORM:CATalog?
This command returns the list of available waveforms by name.
Names can only be numbers. For more descriptive names, see the
."[SOURce:]WAVEFORM:CATalog:ALIAS?" command instead.
<cr>
WAVEFORM:CAT?
1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16
[SOURce:]WAVEFORM:CATalog:ALIAS?
This command returns the list of available waveforms by description.
For each waveform, both the name (number) and description are
returned in a comma separated list.
<cr>
WAVEFORM:CAT:ALIAS?
Sine,Clipped THD 1%,Clipped THD 2%,Clipped THD 5%,Clipped THD
10%,Square Fast,Square Slow,Sawtooth Fast,Sawtooth
Slow,Triangle,Clip 5% THD,Clip 6% THD,Clip 7% THD,Clip 8% THD,Clip
9% THD,Clip 10% THD
[SOURce:]WAVEFORM:COPY
This command copies the waveform file specified as a PATH
parameter to the waveform number specified. The path name is a
delimited string.
<PATH>,<NUMBER>
<cr>,<nr1>
WAVEFORM:COPY "internal/waveforms/1.csv",25
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 280 of 485