Pacific Power Source AFX Series Operation Manual page 273

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]FREQuency:LIMit:MINimum
Sets the lower user limit for frequency programming. Not that the
lower limit set value must be less than the upper limit set value or an
error will be generated and no change to the set value will take place.
The lower limit set value must fall within the source specified
frequency range capability.
1.00 – 1200.0
<nr2>
FREQ:LIM:MIN 47.0
[SOURce:]FREQuency:LIMit:MINimum?
<nr2>
FREQ:LIM:MIN?
47.0000
[SOURce:]FREQuency:LIMit:MAXimum
Sets the upper user limit for frequency programming. Note that the
upper limit set value must be greater than the lower limit set value or
an error will be generated and no change to the set value will take
place. The upper limit set value must fall within the source specified
frequency range capability.
15.00 – 3000.0
<nr2>
FREQ:LIM:MAX 63.0
[SOURce:]FREQuency:LIMit:MAXimum?
<nr2>
FREQ:LIM:MAX?
63.0000
[SOURce:]FREQuency:LIMit:RANGe?
This command returns the lower and upper frequency user limit set
value.s
<nr2>, <nr2>
FREQ:LIM:RANG?
53.0000,63.0000
[SOURce:]FREQuency:SLEW
Sets the frequency slew rate in Hz/msec. This command is not valid
when in DC mode.
0.01 – 1200.00
<nr2>
FREQ:SLEW 100.0
[SOURce:]FREQuency:SLEW?
<nr2>
FREQ:SLEW?
100.0000
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 273 of 485