Pacific Power Source AFX Series Operation Manual page 270

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Examples
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]VOLTage:DC#:LIMit:MAXimum
Sets upper user limit for DC voltage programming for phase #. If # is
omitted, sets all available phases to value specified. User limits must
fall within actual hardware limits of the power source. Also, MIN limit
must be less than MAX limit.
-425.0 – 425.0
<nr2>
VOLT:LIM:DC1:MAX 270.0
[SOURce:]VOLTage:DC#:LIMit:MAXimum?
<nr2>
VOLT:DC1:LIM:MAX?
-425.000
[SOURce:]VOLTage:DC#:LIMit:RANGe?
This query returns both upper and lower user limits for DC voltage
programming.
<nr2>,<nr2>
VOLT:DC1:LIM:RANG?
-425.0000,425.0000
[SOURce:]VOLTage:DC#:LIMit:SATuration:RANGe?
Returns maximum DC voltage at which saturation of the output
inverter will occur. Saturation limits are determined in the maximum
peak voltage capability of the AC+DC components at the output of
the power source. For the AFX Series®, these limits are -425 and
+425V. The VOLT:DC1:SAT? returns the max. DC level that may be
programmed based on the programmed AC wave shape and RMS
level.
Maximum allowable values are:
Maximum positive peak voltage:
V_DC = V_peak_max - V_AC_peak_max
Minimum negative peak voltage:
V_DC = V_peak_min + V_AC_peak_min
V_AC = 300Vrms sine wave
V_DC = 425 - 1.41 * 300
V_AC = 120Vrms sine wave
V_DC = 425 - 1.41 * 120
V_AC = 0Vrms
V_DC = 425 – 0
<nr2>
VOLT:DC1:LIM:SAT:RANG?
-225, + 225
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
(V_DC_sat = 0)
(V_DC_sat = 255)
(V_DC_sat = 425)
Page 270 of 485