Table of Contents
Advertisement
Command Syntax
Description
Parameters
Parameter Format
Example
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]WAVEFORM#:SWITCH
When sent for the selected phase, the output waveform is switched
over to the new waveform name that was last set with the
WAVEFORM#:LOAD command. . If # is omitted, sets all available
phases' waveforms are switched.
None other than phase selected in command string
n/a
WAVEFORM1:SWITCH
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 285 of 485
- Quick Links:
- Block Diagram
Hide quick links:
Advertisement
Table of Contents
