Communication Usb Commands - Pacific Power Source AFX Series Operation Manual

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
8.9.9

Communication USB Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
SYSTem:COMMunicate:SERial:FLOWcontrol
This command sets the method of handshaking used for serial
communications. Available settings are Xon/Xoff or Hardware
handshake.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:SER:FLOW ON
SYSTem:COMMunicate:SERial:FLOWcontrol?
<nr1>
SYST:COMM:SER:FLOW?
1
SYSTem:COMMunicate:USB:VIRTualport[:ENABle]
This command enables USB device control using virtual comm driver.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:USB:VIRT ON
SYSTem:COMMunicate:USB:VIRTualport[:ENABle]?
<b>
SYST:COMM:USB:VIRT?
1
SYSTem:COMMunicate:USB:LAN[:ENABle]
Enables access to embedded webserver using virtual IP Address
through USB interface.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:USB:ETH ON
SYSTem:COMMunicate:USB:LAN[:ENABle]?
<b>
SYST:COMM:USB:LAN?
1
SYSTem:COMMunicate:USB:LAN:ADDress
Sets the embedded webserver virtual IP Address for USB interface.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:USB:LAN ON
SYSTem:COMMunicate:USB:LAN:ADD?
<b>
SYST:COMM:USB:LAN:ADD?
192.168.123.1
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 356 of 485