Phase Programming Commands - Pacific Power Source AFX Series Operation Manual

8.7.5

Phase Programming Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]PHASe#
This command programs the phase angle for the selected phase. A
phase reference (#) must be specified.
Note that unless external sync mode is used, the A phase (# = 1)
cannot be programmed is fixed at 0 degrees.
0.0 – 359.9
<nr2>
PHAS2 122.5
[SOURce:]PHASe#?
<nr2>
PHAS2?
122.5
[SOURce:]PHASe#:SLEW
This command sets slew rate for the phase angle for the selected
phase. A phase reference (#) must be specified.
Note that unless external sync mode is used, the A phase (# = 1) slew
rate cannot be programmed is fixed at 0 degrees.
0.01 – 359.91
<nr2>
PHAS3:SLEW 10.25
[SOURce:]PHASe#:SLEW?
<nr2>
PHAS3:SLEW?
10.2500
[SOURce:]PHASe:ROTation <b>
This command sets default phase rotation at power on. Available
settings are POSITIVE (1) or NEGATIVE (0). This setting effectively
swaps phases B and C and may be used to set the required phase
rotation for AC motors.
[ 0 | NEGative | 1 | POSitive]
0 = NEGATIVE
1 = POSITIVE
<b>
PHAS:ROT POS
[SOURce:]PHASe:ROTation?
<b>
PHAS:ROT?
1
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 276 of 485