Transient Edit Mode; Figure 6-11: Blank Transient Program Screen; Figure 6-12: Transient View Edit Mode - Pacific Power Source AFX Series Operation Manual

6.6.2

Transient Edit Mode

To create a new transient program, press the TRAN key to select the Transient screen. If no
transients have been entered or recalled, the initial screen will be blank.
The only available soft key is the "Create" key (SK1). Press the "Create" soft key to enter the
Transient Edit mode. This will display the TRANSIENT VIEW screen.
In Edit mode, a number of soft keys are available to aid in editing new or existing transient
lists. They are defined in the following table.
SOFT KEY
Add at the end
(SK1)
Insert before (SK2)
Delete (SK3)
Debug Mode (SK4)

Entire Contents Copyright 2016 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual

Figure 6-11: Blank TRANSIENT PROGRAM screen

Figure 6-12: TRANSIENT VIEW Edit Mode

Description
Adds a new row entry at the bottom of the transient list table. If
there are no table entries yet (new), pressing this key will add the
first line of a new transient table.
Insert a new table row before the current selected row. The
selected row and any rows below that are all pushed down one
position.
Deletes the current selected row. Any rows below the selected row
are pushed up one position.
Note: This action cannot be undone.
Displays the Debug Execution mode screen. See section 6.6.3
AFX SERIES® OPERATION MANUAL
SECTION 6: FRONT PANEL OPERATION
Page 97 of 274