Voltage Programming Commands - Pacific Power Source AFX Series Operation Manual

8.7.2

Voltage Programming Commands

Note that most of the voltage programming commands are phase specific so in three or split
phase mode, each phase voltage can be individually programmed. This is done by appending
1, 2 or 3 for the "#" symbol shown in the syntax below. If the "#" value is omitted, all
available phase (1, 2 or 3 in single, split or three phase mode respectively) will be set to the
same amplitude. This allows the same program code to be used for any phase mode as long
as the phase amplitudes need to be balanced.
The following command sets each phase to a different amplitude when in three phase
mode.
SOUR:VOLT:AC1 15;:SOUR:VOLT:AC2 30;:SOURCE:VOLT:AC3 45
This command sets all phases to the same amplitude, regardless of phase mode:
SOUR:VOLT:AC 100
The query format for these phase specific commands will return the value for the phase
number appended to the command. If the phase number reference is omitted, the setting
for phase 1 (A) is returned.
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
[SOURce:]VOLTage:MODE
Results voltage mode as 0 for AC, 1 for DC or 2 for ACDC.
Note: In UPC compatibility mode, only AC mode is available
< 0 | AC | 1 | DC | 2 | ACDC >
<nr1>
VOLT:MODE DC
[SOURce:]VOLTage:MODE?
<nr1>
VOLT:MODE?
1
[SOURce:]VOLTage:CSC[:STATE]
Turns the Continuous Source Calibration (CSC) mode on or off.
<0 | OFF | 1 | ON>
<b>
VOLT:CSC ON
[SOURce:]VOLTage:CSC[:STATE]?
<nr1>
VOLT:CSC?
1
AFX SERIES® OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 265 of 485